Created for CTC Replicator clone to use as replacement for the filament bowden tube.

In the meantime replaced by a better version: http://www.thingiverse.com/thing:631223

This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/cOJXqZxP76n

Suggested printing ...

• PLA (more elastic)
• 40% infill
• 0.3mm layer
• pre-guide with support

You can print the pre-guide upright without support, but only if you have an additional hot-end cooling fan. Otherwise the upright part will be very ugly due to printing hot on hot.