Mircoscope mount for my simple usb microscope.
The original mount from the microscope was not accurate to justify, so i decide to use a worm for adjusting.

I was inspired from this microscope hack:
http://www.hackerspace-ffm.de/wiki/index.php?title=DIY_Mikroskop

10x and 60x magnify works great from the microscope.
the 200x magnifiy is a little bit unstable. i think there have to be a stepper motor version.

For the assembly you need follow hardware:

2 x 8mm about 30cm stheel shaft
1 x M10 about 30cm thread bar
2 x LM8UU linear bearing
3 x M10 nut
2 x M3 20mm
2 x M3 nut

Insert one M10 Nut into the microscope mount and one M10 nut into the gear.
Mount the a m10 nut on the other side of the gear, the thread bar should be have a permant connection with the gear.
Insert the linear bearing into the microscope mount and screw the thread bar trough the m10 nut.
assembly the bottom and top plastic with a small hammer.