Here are some nice removeable Spoolholders for your great Orca Printer :)

the tip of the lower spoolholer is made a bit longer so you can also put 100mm wide rolls on it , they won`t fall of anymore !

Only for 1,75mm filament !

This is a modification from Mendelparts original spoolholder.

Just print them and put them on your printer.

ensure that you printer is well tuned, they fit tight.

should fit PnP on most V40+

For V30 (and some early V40) you need to drill some holes and screws + nuts. 2x M3x10mm + nuts 2x M4x10mm + nuts

the upper part is made for 5mm teflon tube to fit in.