The Cup total sizes are about: 13cmx13cmx21cm(height)

I will give you several references for an optimal printing and post production.

• Triangular base:

Resolution: 0.3 - No supports

I printed it at a resolution of 0.3 for riducing printing time, but the result is very well.

• Cup Rod:

Resolution: 0.2 - No supports

• Ring Rod Joint

Resolution: 0.2 - With supports

This is the piece between the ring holder and the cup rod.

• Ring Holder:

Resolution: 0.2 - With Supports

This is one of difficult to print pieces, becauses of its curves. Supports are required!

• Main Ring:

Resolution: 0.2 - No Supports

Despite its shape, its holes don't need support, for a small print corner.

• Logo Support

Resolution: 0.2 - No supports

Is the piece that fits into the joint.

• Symbol Holder (n°6 to print):

Resoultion: 0.2 - No supports

After print, you have to enlarge a little bit the central hole with a rasp or similar. Pay attention when fit these pieces on the Main ring that it's a little fragile.

• Any simbol (mana + logo)

Resolution: 0.2 - No supports

After print you have to smooth a little bit the circle for perfect fit in the holder.

Lastly i glued all the pieces to make it more compact (I used "Super Attak Gel"). Hope you like it!