Fusion360 file

I don't think they sell my chair anymore. I tried to find it for you guys as a reference. Essentially, this is, I think, an Inland gaming chair that I bought at Microcenter a few years back.

The mousepad is a Steel Series QcK Mini.

The inner dimensions of the mousepad mount (the part that attaches to the arm of the chair) is 73.4 mm wide and 22.5 mm tall. The angle that it sits on the arm is 7.5 degrees left-to-right and 13 degrees front-to-back.

The gray part of the mouse pad mount just slides on the front of the chair arm. It should sit level when the chair is in the reclined position.

I know this is a very niche design, but I thought it was, at least, interesting enough to post. My monitors sit pretty high, so the best way for me to sit and work is with my keyboard in my lap and my mouse next to me. The mouse has been sitting on an end table next to me, but I found the travel distance was inefficient when moving my hand from the keyboard to the mouse and back again. This was my solution.

Each of the 2 pieces was a day to print, probably 40 hours total. Uses four #4x1/2 in. screws.

I don't know what else to say. Ask questions.