I designed this in Fusion 360 and printed it for my wife.

The mirror can be tilted in two axis and be mounted on the back while you carry the box around.

I printed all stuff in either white or pink PLA 0.2 20% infill except the Mirror-Side-Screws-And-Nuts.stl which I printed with 100% infill.

Pink filament used was https://shop.prusa3d.com/en/filament/45-pink-pla-filament-1kg.html#

White filament was https://addnorth.com/sv/shop/product/ANPL17WHI

Other stuff needed

1x Square mirror XxX 5mm thick 40x Woodscrews 40 x M2.5x12 6x Magnets round 10x2.4

Partslist

• 1x Back.stl Back wall of box
• 1x Bottom.stl Bottom part of box
• 1x Top.stl Top part of box
• 1x Wall.stl Left wall of box
• 1x Wall-Right.stl Right wall of box
• 2x Side-Holder.stl Compartment on the outside of the walls for brushes
• 1x Top-Handle.stl Top carry handle
• 1x Mirror-Holder.stl Top mount for mirror
• 1x Mirror-Stick.stl Mounting stick for mirror
• 1x Mirror-Base.stl Construction for holding the mirror
• 1x Mirror-Case-Sides.stl Sides that hold the mirror
• 1x Mirror-Case-Horizontal.stl Bottom and top part that holds the mirror
• 1x Drawer-Handles.stl Handles for the drawers
• 1x Mirror-Top-Cover.stl Top mirror cover with hearts
• 1x Drawer-Bottom.stl Bottom drawer
• 1x Drawer-Middle.stl Middle drawer
• 1x Drawer-Top.stl Top drawer
• 1x Mirror-Screws-And-Nuts.stl Mirror screws and nuts
• 1x Mirror-Holder-Back.stl Mirror mount for the back while carrying the box