This stamp handle is designed to house a 4x4cm stamp. However it can be scaled and stretched freely while remaining functional.

As of the stamp itself I got some special material lasercut at school, Some handcut lino should work fine. A square of double sided tape holds everything together like a charm.

I'm thinking of implementing a sort of slot-in sleeve to the design to be able to swap the stamps without needing more than one handle, leave a comment if you'd be interested.

Should you want a model scaled differently contact me and I can whip it together.

Scale the model to match the measurements of your rubber imprint.

Double sided tape holds the rubber and the handle together nicely.

For best results if you're printing out of ABS, melt a little bit of filament in acetone and brush it on the hotplate before printing. This should make the bottom of the handle very smooth which is good for tape.