FlashForge Finder side mounted 1kg+ spool holder With my side mounted spool holder you can have 3x spools sitting on your machine at one time (counting the internal mount)

Features:

• Ambidextrous design: Mount either left side or right of the machine
• Base of spool holder contoured to fit snugly on rim of printer
• 1~cm added width to dimensions of FlashForge Finder per holder

Directions:

• Print the bar standing up
• Print the sides with the clips positioned to the floor bed so you don't need supports
• Print the base flat side down with legs up, also printed without supports

You will need to print 2x walls, please position them pointing outward with the clips facing inward on the base. Gently use a screwdriver or something to press in the clip while attaching it to the base. I've printed this multiple times on my Finder and while the tolerances are tight it is generally an easy fit. If the tabs should break, feel free to apply super in the slot and you'll be good to go. The curved design is to allow you to slide the bar into your spool then roll it up to where it will sit during the print

Pro tip: Use tape if you'd like to fix the mount to the side middle (best position) but from my experience it isn't really necessary based on the pull on the spool.