A replacement set of controls if you have sticky buttons or just prefer a more industrial feel to your 3D printer.

NOTE: added a shallow body and a mounting blank

Using a small micro-switch joystick + 2 momentary push buttons for select and reset with shroud to prevent accidental pressing + a switch for those of you that have fitted LED lighting and a separate "back box" with a 5 degree angle.
The front panel will glue to the surround and the angled face mounts to your printer (choose your angle up or down before glue), all should fit over your existing buttons but you can choose your own fixing method.

I printed in PLA, 100% for the fascia part and 30% for the surround, 0.27mm layers.

Part list included as a text file...

Control Joystick
www.apem.com
V4 Screw Mount Joystick - microswitch
44mm wide - 36mm between fixing points
41mm high and 23mm behind
15mm handle dia
20mm cut-out
NOte: When fitting lightly bend the two connections that protrude on 3 sides to get a "snug" fit to the back surround.

LED Lights Switch
SPDT
3A 125vac
3.5mm hole

Select Button (Black)
unknown supplier
12mm hole - silver/black
2a 250v Large Momentary push to make 2 pin

Reset Button (Red)
Maplin - FH91Y
50v 1a Large Momentary push to make 2 pin