So after making a low poly chicken ( https://www.thingiverse.com/thing:2922636 ), I made a low poly rooster to keep the chicken company! Yay!

Thanks to iPa64 for the original clean version of the rooster and joerodman for the idea to split it for printing, that tail is nuts.

You'll need to use the lay flat feature to lay the flat sides on your bed, sorry I'm lazy.

This time I used 4 perimeters and 10% infill. Looks pretty good. I printed this in PETG and had some warping (no heated chamber and its really cold here atm.)

Even though the supports fell down in some cases overall it looks really good, I guess I didn't need those supports.

If I were to change anything I'd:

1. Cut the model so the leg is more even (the front is quite thin making separation from the raft difficult), sorry I just don't know how to do that yet.
2. Join the feet to the disk better. At the moment it prints with gaps between the bottom of the feet and the disk but they seem to join okay anyway.
3. Tidy up the right leg where it joins the body That being said, it prints fine as is.

I included the low poly version of the single piece.