Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Wife wanted a frog house so I fired up the (ok...its never "off" per say) CR10 S5
This is the frog I used and scaled up to fit my needs: https://www.thingiverse.com/thing:2136760 Base was printed at .2 and 3000mm/min @ 20% infill; no supports Top was printed at .2 and 3000mm/min @ 20% infill; with supports
Attached frog with Gorilla glue
All printed in Solutech PLA Sliced with S3D Designed in AD Inventor
20
Curtidas
0
Downloads
23
Coleções
Licença
Creative Commons - Attribution - Non-Commercial - Share Alike
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta