Radial Engine ( Compressed Air Engine ) Experimental

Hi guys, This model is an experimental project.

It might be evolving and you can modify as you want to make the best version of it.

Don't hesitate to make your own and to upgrade it. Please send me a message if you made some modifications.

Update:

17/05/2018: Add rubber scal ( NinjaFlex Semiflex )

Other parts required:

=> 1 pcs Pneumatic connection 6mm male thread R1/8 Connector Push to Connect => 1 pcs M4x45mm bolt (this can be any desired length) => 10 pcs M3x10mm bolts => 30 pcs M3x30mm bolts => 2 pcs nut M4 => 3 pcs washer M4 => 6 pcs washer M3 => 2 pcs 604-ZZ bearings => 10 pcs 3mm brass collars (these can be cut from brass tubing with inside diameter of 3mm and outside diameter of 4mm)
First Test: [https://youtu.be/3oi1DlCIssU](https://youtu.be/3oi1DlCIssU)

Assembly video instructions: https://youtu.be/T6aWXmJwaBY

Disclaimer:

If you wish you 3D print this engine, do so at your own risk. Working with high pressure air is DANGEROUS and I hold no responsibility for your actions. All parts were printed to the highest strength possible and I can't guarantee that your parts will be the same.

Descrição

Radial Engine ( Compressed Air Engine ) Experimental

Update:

Other parts required:

Disclaimer:

Radial Engine ( Compressed Air Engine ) Experimental