Heavy duty spool holder that should work with most spools.

Print one spoolholder2 and two spoolholder2B. Push the spoolholder2B into the sides of a 11cm long, 50mm diameter plastic pipe(commonly used as sewage pipe). Put one 608zz bearing on each side and slide a 15cm long 8mm rod through it all.

I have 6 of these currently in use and am super satisfied, unspools easily without "overspooling".

You can check out the other projects here: http://www.youtube.com/c/MrCrankyfaceProjects.

Check me out at: Youtube: http://www.youtube.com/c/MrCrankyfaceProjects Instagram: https://www.instagram.com/mr.crankyface/ 3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface