Parts safe for printing: MiniMasterSpoolBottomV5 MiniMasterSpoolTopV6

[Updated: 03-03-2018] The MimiMasterSpool Is currently in a very usable state. I have updated the bottom and the top to V5 and V6 respectively. There are 3 cable tie ditches available for pulling filament off the spool, or putting it back on. There is a hole through the center to allow for you to insert the end of the filament. There are also 4 filament end storage locations for keeping the end of the filament in a safe spot. this allows for stacking as well. I have thickened the spool ends to reduce flexing when winding or adding filament to the spool.

The Yellow portion was printed on a Prusa I2, the white half was printed on my Mp select Mini V2. Do not use support material at all! if you do you will have a fun time cleaning the threads...

Please let me know if you print this spool, leave any comments and or suggestions. Thanks.

[Updated: 02-28-2018] Fusion 360 crashed on me and I lost a few modifications to the spool, I'll have to fire everything back up again and get back to where i was. I'll update as soon as I can.

[Updated : 02-19-2017 9:39PM] THIS UPDATE HAS NOT BEEN TESTED YET. I have added end management to the spool, I have also reduced the thickness in some spaces to make for less filament use and quicker print times. currently at 0.3mm layer height and 50mm/s bottom prints at about 2 1/2 hours with no raft. I am in the process of printing MiniMasterSpoolTopV3 and MiniMasterSpoolBottomV2. I will update when I have printed these sets.

[Updated : 02-19-2017 6:14AM] Spool works, you should be able to print. results may vary by printer.

[Updated : 02-18-2017 10:28PM] WARNING Thing is being test printed right now, Test print threading match, printing V2 of top now. Ill add filament management features soon.

Summary: I have an MP select Mini V2, the build volume on these guys is pretty tiny. 120,120,120 (mm) So I wanted a spool that I could print on that printer.

Enter Mini Master Spool, modeled after RichRap's awesome Master Spool design. This one does not have all the bells and whistles of his as of yet. I will update the spool to provide such features.

This spool may work for sample filaments or just bits of filament you have laying around. its a little smaller than the 250gram .5kilo spools, i cant remember what one this is. the Bottom printed portion is sitting on a injected mini spool for reference.