Organize your cables and wires by using cable combs. This customizable thing can produce both open (clip on) and closed combs in all kinds of sizes. You may change a lot of features to fit your needs.

This thing uses a few levels of value verification to ensure the values you put in are feasible. Remember that printers can be crude and require more material to create a solid part. I recommend adding a bit of rigidity through the "Strength" value and increase the "Wire diameter" beyond your measured diameter due to the (often) small print moves which most likely fall off a bit short.

CHANGELOG

v1.5 - 2019-02-09

• `IS_CLIP_ON=1` with negative `HORIZONTAL_SEPARATION` now span across the whole part

v1.4 - 2018-12-08

• `TYPE="demo"` introduced to demonstrate all other types
• Each type is now separated into it's own module
• `SIZE` is now automatically calculated based on `WIRE_DIAMETER` and `EXTRA_STRENGTH`

v1.3 - 2018-12-05

• `TYPE="slim"` with extreme `VERTICAL_SEPARATION` produced separated meshes
• Assertion added for `IS_CLIP_ON=1` with more than 2 rows
• `ROWS=1` and `IS_CLIP_ON=1` now has a single open side rather than two
• Assertion warnings may now be switched off using `IGNORE_ASSERTS=1`
• Wires can now be spaced apart using `HORIZONTAL_SEPARATION` and `VERTICAL_SEPARATION`
• `TYPE="cut-away"` introduced which can be cut to size after printing