Sixth of the modular paint racks to store and organize hobby paints. This one is a smaller straight section that is for wall hanging. I designed this to hold Vallejo or Reaper dropper paint bottles. I will be adding more shelf layouts to hold paints such as Miniataire, GW and others!

Capacity:

• 20 dropper bottles (Vallejo, Reaper, Army Painter)
• 16 Minitaire bottles

Dropper style bottles can be stored in the upright or inverted position. I designed it more for the inverted position as that is the way I hold my paints to prevent tip dry out.

You will need to print the following to assemble one unit:

One of the following:

• LeftSide-WallSmall
• RightSide-WallSmall
• BackSupportBottom-WallSmall
• BackSupportTop-WallSmall

Four of the following

• FrontHolder-WallSmall-(bottle style)
• BackHolder-WallSmall-(bottle style)

To attach the top back support I have added screw fasteners since it will be hanging on the wall. You will need two 6-32 1/2" flat head machine screws and nuts. These are readily available at most big box hardware stores. After assembly just put the screws in with the head on the outside and hand tighten till secure.

The hanging holes in the back are made to take #4 screws. Use wall anchors if not drilling directly into a wall stud to hang.

Luckily these pieces would fight on the print bed but if it doesn't on yours you may have to split them and glue the two halves together. Assemble with the tabs and slots. I would also suggest glue just to be safe in case you have to move it even though the fit should be pretty tight.

Hope you enjoy this and it gives you more options to tidy up your painting desk.

Other units in the series: Large Straight - https://www.thingiverse.com/thing:2531450 Small Straight - https://www.thingiverse.com/thing:2549451 Inside Corner - https://www.thingiverse.com/thing:2543779 Outside Corner - https://www.thingiverse.com/thing:2588073 Tool Holder - https://www.thingiverse.com/thing:2601038

Upcoming:

• Additional shelves for more paint brands

Revision History:

• 01/18/2018 - Added two new files for Minitaire paints. The new front holder FrontHolder-WallSmall-Minitaire.stl and a new back holder for the very bottom BackHolder-WallSmall-Minitaire.

Happy Printing!!!