Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
A Raspberry Pi Zero camera case with with snap on back plate. This was designed as part of an OctoPrint project for the Felix 3D printer.
Instructions:
-
With the case and back plate printed insert the Pi camera as shown in the picture below.
-
Fully seat the camera making sure the camera lens passes through its hole and the board is being retained by all four clips. You may need to push the clips to the side in order to slide the camera board past them.
-
Next, attach the 38mm camera ribbon cable.
-
Place the Raspberry Pi in the case, securing it with the snap-in back plate.
122
Curtidas
0
Downloads
198
Coleções
3
Impressões
Tags
octopi
octopi case
Octoprint
OctoPrint case
pi camera
Pi camera case
Pi Case
pi z camera case
pi z case
pi z w case
Pi Zero
pi zero camera case
Pi Zero Case
pi zero w
pi zero w camera case
Pi Zero W Case
pi zw case
PiZ
Raspberry Pi
raspberry pi camera
raspberry pi case
Raspberry Pi Z
raspberry pi z case
raspberry pi Z W
Raspberry Pi Zero
Raspberry Pi Zero W
raspberry pi zw
Licença
Creative Commons - Attribution - Non-Commercial