I needed a wall mount I could use to semi-permanently mount my Innova 3320 Digital Multimeter in above my work station, so I threw this bad boy together. The idea is that I never remove my MM from the wall, and just unwind the chords when I need them.

Should work for MultiMeters with dimensions equal to or slightly less than: H=137mm W=73mm D=32MM

Includes a small tray for additional tips on the left.

Comes with a separately printed cable bracket, attached with a countersunk M4 screw & nut (cause that's what I had laying around). Mount to your wall with any sort of countersunk self-tapping screw with a thread outer diameter equal to or slightly less than 4.5mm.

There are two models for the mount itself. After I printed/installed the first model, I realized the storage tray on the left was too large and my tips kept falling into the bottom and were hard to grab. So I added a divider to keep this from happening (though I haven't actually printed and tested this model so any feedback on it would be good).