This is the Taz 6 specific variant of the Openbuilds X axis rail modification - non antiwobble edition. For the Anti Wobble equipped version of this project, please check out: https://www.thingiverse.com/thing:2690825

Instructions are still being worked on. it's basically identical to the Taz 5 version, but with slightly different bolts for the X ends.

X motor end 4x m2 heat set inserts 2 20mm M5 cap head bolt 1 12mm m5 Cap head bolt 2 M5 T slot nut 2x M5 heat set insert

X idler end 2 20mm M5 cap head bolt 1 12mm m5 Cap head bolt 2 M5 T slot nut 2x m3 heat set inserts 2x 10-12mm M3 cap head bolt 2x M5 heat set insert

X motor mount 4x 10mm M5 6x M5 11mm Long Heat set inserts (Mcmaster carr ) 4x M5 T slot nuts X motor mount plate 10mm M5 bolts 6x 12mm M3 4x bolts

X idler mount Stock Lulzbot idler bearings, washers, Nut and 8mm bolt 2 6.75mm long M5 Heat set inserts 2 M5 32mm bolts (the idler adjusters 2 10mm M5 bolts 2 M5 Tslot nuts X Carriage adaptor plate 4x M3 8mm bolts 11 M3 heat set inserts (the short 3mm-4mm ones) Stock Lulzbot V notch plastic piece. Stock 4 bolts and washers that hold down that piece (M3 10mm thread plus M3 washers) The stock Lulzbot carriage hold down bolt and washer (M3 washer M3 bolt 10mm thread)

Backplate 1 35mm long M5 low profile bolt (I use the openbuilds ones) and 1 35mm long M6 bolt (or ¼” bolt) Printable spacers 2x 1/8" bolt, 1 inch or so long 4x 1/8" nuts 4x large-ish washers bigger than the plastic spacers to keep the bolt slipping off the end You will need much longer bolts if you are attempting to use the printed backplate.

I still have metal backplates available.

Openrails parts: 1 60mm x 20mm Openbuilds linear extrusion 500mm long extrusion, Manually remove 40mm to end up with a 460mm long X rail . http://openbuildspartstore.com/black-v-slot-linear-rail/ 4 sets of bearing wheels (http://openbuildspartstore.com/xtreme-solid-v-wheel-kit/ or other sets) , 4 spacers (6mm ) http://openbuildspartstore.com/aluminum-spacers/ 2 eccentric spacers also 6mm http://openbuildspartstore.com/eccentric-spacer/ one of their Gantry mounting plates. http://openbuildspartstore.com/v-slot-gantry-plates/ Flat head M5 Bolts and nuts 30mm (standard bolts will not fit, need the flat ones. ). Longer if you plan to add the cable chain pieces