Beetles were devouring my grape vines down to bare stems. I had an abundance of bags and bait, but only one hanger... so I printed more.

This trap has only been in place for a few minutes and already has a couple dozen beetles in it.

WARNING: This is a large (but flat) print. It is roughly 6 inches wide along the X and Y axis. It fit on my mendel reprap, but will not fit on every printer.

Download the STLs for direct printing. The *.ipt is the source file, which was drawn in autodesk inventor.

1. Print the two halves (seen here as "Bug Trap A.stl" and "Bug Trap B.stl")
2. Slide the two parts together along the notch at the center
3. Attach a bag and bait as per usual trap configuration
4. Tie it off to a post using the two holes at the top of "Bug Trap B.stl".