The ultimate bug trap on thingiverse.

This is an on going project. I just finished the design and haven't printed the parts yet. but if someone wants to give it a try, please go ahead. Please share your make.

You will need 4 m4x40+ bolds and nuts 12 x m5 UV or Blue LED's 4x 180ohm resistors 110x110x25mm Fan (220v better) a 220 to 12v transformer and some glue

Print all parts one time only the legs 4 time the LED_UV_Lamp.stl needs to be printed with Transparent filament Then use White or a Glow in the dark White filament for fat_top_plate. rest doesn't matter

Updates will follow!!!

Cheers

Updates:

Oct 10 2017: Electronic_Housing_side has been replaced with a newer version. the side was to thin, it became a big spring after printing.

Oct 11 2017: I have printed the LED_UV_Lamp I suggest to print the 1st 6mm with 3 or 4 shells and 50% or more infill the use 2 shells and 10% infill for the rest. this make the parts that has the led's more translucent. just becareful when you take the part of the heatbed, those pins are east to break off