Update 9-18-2017 There was a bug after I rearranged the code that messed up the bottom seal slot when you turned off the vent, this is fixed.

Also I have successful printed a vent section and it fit first try (thankfully) I will upload the test prints soon.

This is a customizable window vent for a laser cutter, dryer, AC ect

The first section with the vent will need supports. The height of the sections can be adjusted to fill the window in printable sized portions.

Available Variables

//// // Variables ////

//**************************************// //--Work Piece Options--// //1 = Yes, 0 = No IsVent = "yes"; // [yes,no] //Is this a vent IsPeg = "yes"; // [yes,no] //Is there attchment pegs IsHole = "yes"; // [yes,no] //Is there attchment holes IsSealR = "yes"; // [yes,no] //Is there a seal ridge IsSealS = "yes"; // [yes,no] //Is there a seal slot IsClampBO = "yes"; // [yes,no] //Is the a clamp Bottom Offset

//**************************************// //Work Piece Vars WorkH = 200; //Hight Of Work Piece WorkW = 185; //Width Of Work Piece WindowW = 39; //Window Width

//**************************************// //Clamp Vars ClampT = 7; //Thickness Of Wall ClampCWO = 0; //Cavity Width Offset ClampSL = 30 ; //Clamp Side Length ClampBO = 5 ; //Clamp Bottom Offset

//**************************************// //Wall Vars WallT = 10; //Thickness Of Wall

//**************************************// //End Vars EndT = 7; //Thickness Of end EndCWO = 0.5; //Cavity Width Offset

//**************************************// //Vent Vars VentT = 5; //Thickness Of end VentOD = 97; //Vent Outer Diameter VentL = 120; //Vent Length VentXO = 15; //Vent X (Length) Offset VentYO = 60; //Vent Y Offset VentZO = 50; //Vent Z Offset

//**************************************// //Peg PegLR = 5.85; //Peg Latch Radius PegSR = 5; //Peg Stem Radius PegL = 12; //Peg Length PegSW = 3.5; //Peg Slot Width PegSD = 1; //Peg Slot Depth PegNC = 0.1; //Peg Neck Clearance
PegBC = 0.2; //Peg Ball Clearnace PegSC = 0.5; //Peg Shaft Clearnace

//**************************************// //Seal SealW = 2; //Seal Width SealH = 4; //Seal Height SealHG = .15; //Gap Space Around Seal