2 layer board of 5.30x1.35 inches (134.62x34.34mm). $35.80 for three.

What do you do when you need to drive multiple stepper motors with the same step, direction, and enable pins? If you're in RepRap land, you just connect two steppers to the same output. This is dumb. I have a project that needs to drive four steppers for the Z axis of a printer. The easiest solution? Break out the Step, Direction, and Enable pins on an A4988 socket to four different motor drivers. This is the project that does the job.

Find this awesome project HERE

Link to purchase boards at OSHPark - helps to include it huh?

Licensed under the "Do what the F*** you want Public License"

No...seriously :)

Fred Harman is a suspension bridge near my hometown, and is there for a place holder