3d printed grenades, no support required, pull the pin and throw the spoon will spring up like a real grenade! looks and feels good and is full size 1-1.

I got the idea from XDr4gonx's grenade so i feel i should mention him and say thanks for his input as the larger grenade is almost identical.

Larger grenade is hollow, m10 is solid so feels heavier but both are rough and heavy in hand.

1. glue the spoon together as shown in diagram.

2. put 2 small screws through the nearest hole and lightly tighten

3)in the small hole in the top of the block push in a spring from a pen.

4. inside the spoon youll see a nipple, dab a bit of glue and attach the spring to it (dont glue in the hole

5. push down the spoon and use a split pin and ring to slide in the further back hole of the spoon.

6. pull the pin and throw!! :D