A brio compatible diesel engine

UPDATE 02/09/17

• corrected position of holes in diesel_base (use v2)
• increased diameter of pilot hole for furniture stud in brio_base_3ax (use v2)

Print the following:

• 1x diesel base
• 1x diesel body
• 6x wheels (supports needed)
• 1x diesel face
• 1x brio base 3ax

I used the following to make the magnetic connectors:

• 2x 12x3mm ring ferrite magnets with 3mm hole
• 2x Silver upholstery nails 11mm diameter

For the wheel axles I used:

• 3x 30x2mm metal rods

General notes

• The face is rubbish; hopefully someone will remix a better one!
• I used superglue on all joints and to stick the face on
• I used acrylic to add detail to the face
• I used a hammer to get the upholstery pins in