This is a night light base, it fits a custom made RGB leds controlled by a arduino mini pro and a rotary encode with a push button. (Yep overkill, but it's what I had laying around)

I used these arduinos and encoder: https://www.amazon.co.uk/gp/product/B007YQZUEE/ref=ox_sc_act_title_1?smid=A1NBUX8FDB1DWX&psc=1 https://www.amazon.co.uk/gp/product/B0085I4D5C/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

But any should work.

Turning the the encoder controls brightness, pushing it cycles the colors, at the moment the cycle is {off, white, red, green, blue, magenta, cyan, yellow};

Arduino code included, pinouts are in the code. Leds are fully addressable type, I just cut 3 off some leftover ones from another project, usually these are sold in 2-3m runs, something like this: https://www.adafruit.com/product/1138

For the power supply I just cut a regular USB cable used the red and black (5V and GND) and plugged that in the Arduino. For this amount of leds any USB brick should work, with 3 LED's it uses up a maximum of 140mA, but at night light levels it usually used around 40mA (it's very bright at full power).

The idea is to put a hollow figure on top like the one pictured: https://www.thingiverse.com/thing:1912559

Made it for my son, and he wanted the option to remove the figure, to take it to school, etc.

I will print/make a knob at some point, it's harder for me to rotate it than for me son so it wasn't a priority.

Enjoy.