2018-03-14

• Uploaded bladeScraper-002.stl

• Disregard the first two, this one is vastly superior.

• uses 4 magnets now, glue them in.

• Printed mine at 0.08mm, PLA.

• Simple blade support that helps angle a standard large "NT cutter" / snapoff cutter blade correctly to help get it under the edge of prints while avoiding cutting into your buildsurface. https://www.google.com.au/search?biw=1376&bih=644&tbm=isch&sa=1&q=nt+cutter+blade&oq=nt+cutter+blade

2017-10-15 - NEW version: bladeScraperC-layer0@0.2mm_otherLayers@0.1mm.stl

• Closer tolerance against rear edge of blade, allows entire scraper to easily slide under most prints (old one tends to catch on the print).
• Print layer 1 as 0.2mm, other layers at 0.1mm - for perfect as-designed alignment. 100% infil may be useful, but isn't required.
• uses two 6x1mm magnets to hold the blade on. Glue the magnets in. https://www.aliexpress.com/wholesale?catId=0&initiative_id=SB_20171014070610&SearchText=6x1mm+magnet
• Designed for 0.4mm nozzle, as before.

OLD version comments:

• Use smallest layer resolution possible.
• It intentionally does not "hold" the blade so once you get it under the print yo can remove the block and just move the blade around under the print.