Special type of solid / flexi connector can be used in CNCs aplication or anywhere you need to connect motor with 5mm shaft and 6mm stick or another shaft.

Plastic parts was designed on motor Microcon NEMA-17 1005LCQEF, but it can be used on another type motor with 5mm diameter of the shaft.

To complete the assembly you need to have:

• GT 2 pulley (the connector was designed to assmbly with this type of pulley on the motor shaft)
• motor with 5mm shaft
• another 6mm shaft
• M3x15 screws (2x)
• M3 washers (4x)
• M3 safety nuts (2x)
• M3x12 set screw (worm)