I looked around for a tool holder for the accessories that came with the Lulzbot Mini. When I did not find one that I like, I decided to design one myself with FreeCAD. Some of the design goals are: • tool-less installation and removal • out of the way of the acrylic enclosure • out of the way of any moving parts • maximize functionality while minimizing filament weight • no support generation required

Available slots: • 25x3mm (clam knife) • 25x10mm (pliers) • 18x9mm (dial caliper) • 12x8mm (tweezer) • 30mm dia. (fat glue stick 22g/0.77oz) • two 10mm dia. • two 1/2 inch dia. (Sharpie marker) • general-purpose pocket

Installation: • push bottom down at an angle onto the Mini's frame • push top inward to snap into opening • slide toward the front to engage clip

Give this design a try. Please leave a comment or send me a message if you have suggestions for improvement.