I'll try to modify these if I get feedback. Other Hypercue Usefule Things from me: https://www.thingiverse.com/thing:2426811

1. -BLTouch Mount V3, this should not require modifications to the original carrier and should be interchangeable with an inductive sensor. Its meant to use a 3mm Tap on the plastic and the screw kit recommended should have M3 screws that will suit this purpose.

2. -45mm Bracket Slotted with a 15mm long slot, this was requested on facebook. This might limit your nut selection.

3. -100mm Spacer for easy of assembling dual Z-axis frame

4. -100mm Spacer for easy of assembling dual Z-axis frame, that only prints at 118mm long

5. -3030 3D joined connector Endcaps and Endcaps: https://www.thingiverse.com/thing:2426811

6. -10mm Cut Jig for silicone tube heated bed supports and 10, 11, 12, and 13 mm cutting jig, just put a second razor in the end of the distance you need.

7. -"Retainer_1.1" Hot End Retainer that is 1mm thinner. The stock one did not grip my hot end, so took a little off and now grips tightly

8. -BLTouch Mount for use with the E3D Lava hot end, which is 8mm taller.

9. -"Retainer_1.2" Hot end retainer with 1mm removed like #7, but with a little deeper radius on the sensor holder cutout. Same diameter, just 0.75mm deeper.

10. -X-Carriage for Igus RJZM-01-08. Despite these being supposed drops for the LM8UU, I found the diameter to be 1mm thicker than my LM8UU and edited this part accordingly.