Estás en 3DFinder

Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.

Modelo 3D SD reader man por JobSmolders en Thingiverse

Descripción

I have lying around these SD card reader/write usb sticks. Many people must have them, because they are free with many cheap printers from china.

But they are not very handy to use, because the card goes in so deep that it's hard to get them out again. So have cut a part of it's housing off --> see picture :-) Then the card reader man came into my mind. :-)

printed in ABS and it can also hold 7 micro SD card's.

PS:I recommend that you print the arm with a BRIM. I used a resulution op 0.2 mm but this object is so small, that you might want to go for 0.1mm :-)

Head and body are fitted with little screws, but you can also glue it. His right arm is glued anyways :-)

Thingiverse

SD reader man

JobSmolders

Me gusta

Descargas

Colecciones

Impresiones

Etiquetas

abstract anet anet a6 holder man micro SD micro SD card Micro SD Card Holder reader SD Card Holder sdcard sd card simple usb usb cable writer

Licencia Creative Commons - Attribution - Non-Commercial - Share Alike

Archivos (4)

sd_reader_man_arm.stl 2.7 MB

sd_reader_man_front_head.stl 3.8 MB

sd_reader_man_back_head.stl 4.6 MB

sd_reader_man_body.stl 6.3 MB

Ver en Thingiverse

¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.

Crear cuenta

Comparar ahora