Feet designed specifically to raise the Hypercube frame and thereby enabling the full utilization of the 2020 extrusions. The radius of the bottom part of the feet is made specifically to the size of Ikea's Fixa floor protectors. With the pads it should remove some of the noise being transmitted to the surface it is standing on.

http://www.ikea.com/us/en/catalog/products/24155600/

Should give a few more cm's in print height if Z stepper and rod mounts are placed on the underside of the extrusion as seen in the images.

Print settings:

• 3 Perimeters
• 3 top/bottom layers
• 0.2mm layer height
• >= 20% infill