My work desk is a mess

Got some gopping yellow plastic (hey good quality just dun like it) and had to find somet to do with it.

Print n build, the trays slot into the hubs and the nut screws down clamping them.

Printed 0.3mm layer height, 30% infill, 2 Perimeters

The feet are the same but use a couple of flat screw drivers in the slots to twist the bottom nut tight, it will clamp the legs solid but you need the rod flush with the bottom nut... sorry was only way could think of achieving narrow legs.

Oh rod is M8 as long as you need and 2 nuts

One important note you need 3 off rubber / plastic pads for the ends of the feet max diameter 13mm, included photo of wat I used.

No more text avin a drink enjoy