I found these cheap 1 dollar flashlights at walmart, and decided to get creative. for this you will need:

• 1 of these: https://www.walmart.com/ip/Generic-5026-Ozark-Trail-9-LED-Mini-Flashlight/34350005

• or 10, I won't judge: https://www.walmart.com/ip/Ozark-Trail-5026-Ozark-Trail-10-Pack-9-LED-Mini-Flashlight-for-Camping/49332939

• Keymod nuts and screws: https://www.amazon.com/gp/product/B019LBCK5Q/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1

• 16 Ga wire (or filament, but its weaker.

Assembly instructions:

1. print both halves of the light mount
2. cut a length of 16 ga. wire slightly shorter than the overall length of the mount.
3. using pliers or a clamp press the wire into one of the long hinges on the mount.
4. again, press the other half onto the exposed half of the wire.
5. cut a short length of wire to insert into the bottom locking hinge.
6. bend the remainder, and trim so it doesn't stick far from the mount.
7. install the keymod nuts by pressing the nuts into the large oblong holes, then insert the screws into the other side and tighten until they have grip on the nuts.