This template defines where the holes get drilled on a simplified Mendel deposition bed. It is designed to be used with the orher simplified components: Y feet, Y belt clamps and skinny Y motor mount.

Cut a square of flat, stiff material about 9mm thick such as MDF or acrylic. It should be 230x230mm. Print the template to scale (centre hole pairs are 20mm apart or check against parts) and line up the centre of the hole pairs wirh the centre of the sheet. Using a spikey punch, nail, awl, half a dart or similar mark the board through the paper. Drill holes where marked to suit screws.

For full assembly details of the simplified Y axis see http://reprap.org/wiki/Y_Bed_Simplified