Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Modelo 3D Needle Puller por 5490robert no Thingiverse

Descrição

This is a simple needle puller, used to effectively remove the needle, or pointer, from gauge's and clock's, without damage.

I have used a Cap Screw Head M5 25mm, for the bolt to push down on the pivot or pointer shaft of the gauge, A fine tip is needed at the end of your bolt, around 1 - 1.4mm should be ok.

If you have a M5 thread tap you can use this to start a thread in the body of your puller. If you like you can print a fancy handle for the cap, its a very snug fit, just turn a little as you push it together.

Thingiverse

Needle Puller

5490robert

32

Curtidas

0

Downloads

60

Coleções

1

Impressões