This is a work in progress to make a hinge compatible with raisers from Ikea Lack raiser and window holder

It's heavily inspired by Lack Table Enclosure Parts, but redesigned from the ground.

This is a first try with Tinkercard after 15 years without doing any 3D modeling, so expect some improvements ;-)

The inner part of the hinge is a little bit loosy because it's 1mm smaller than the outer part as I didn't found a way to model shapes with decimal measurements with Tinkercad.

I did not remixed hinge from this thing as I wanted to be able to remove the window easily.

This will fit M4 screws.