A small case for the split version of this reciever module: http://www.banggood.com/Realacc-RX5808-Open-Source-5_8G-40CH-Split-Receiver-with-OLED-Special-for-Fatshark-Goggles-p-1068207.html

I kept it simple and small. I used ABS with 20% infill to print. Screws: Hex m2x7,5mm from an T-Rex450kit or whatever you can find. It fits the buzzer of 11,9/12mm diameter. The display module is kept in place using double sided tape (on the lower stand), the diversity module can also be taped - mine hold quite good.....

There are two versions of the case for the display module:

• soldering version (see pictures)
• one for the video-cables to be connected using crimped servo-plugs

My cables always got loose when carrying my googles so I switched for the soldering version.

In the picture you can see another small casing. It's for my video-switch for VCR playback. I only had a pretty big 3-way-switch lying around. Maybe somebody also has a use for it, so I uploaded it too.

Happy FPV-ing!