This is a small Tackle box. Or, it could be a tiny part storage box. Simple, but effective. I may alter the dividers in the future. It can be printed without any support, and does not require any pins or hinge parts to assemble. It just snaps together! It can be scaled up or down, but be wary of loosing tolerances when scaling up. Use your normal print settings for PLA or ABS, but I recommend printing slowly around 35-50mm/s for best quality. Also, I recommend using ABS or PETG for strength in case it is dropped.

I printed the prototype, then made some minor changes to the hinges and snap closure. Then my printer died in the middle of the night, so I was not able to print the final version to verify tolerances. Please let me know if you have any problems with the print. In the meanwhile, I guess I will be trying to figure out the issue with my printer, or looking for a new one.....ugh...