The idea behind this thing is to highlight something you have achieved, so once in a while you stop by and remember what you got. You can also use it to show off, but that's not the point.

The glass figure is actually a trophy, a little reward by our town when you have achieved some sort of upper educational level.

#####Partlist

• 3 high intensity 5mm LEDs, white
• 3 resistors, 150 Ohms/0.25W
• 1 Micro USB B female PCB connector
• wires
• some hot glue

The holes for the LEDs are 6mm wide on the upper side of the platform and 8mm wide on the bottom, so the leads and plastic enclosing of the LED fit perfectly. The micro USB connector is a bit tricky to install, but you can use small pliers and carefully push it into place. It is even possible to solder the connector to the wires after installation.