The wires from the Z stage on the Makerbot Thing-O-Matic are free to rub on the edges and screws of the Makerbot. These wire clips keep the wires from rubbing on anything and are flexible enough to follow the Z stage.

1. Print out one of these clips (the defaults should print just fine)
2. Clip to the top of the Makerbot or close fascimile
3. Position one of the wires in the clip
4. Move the Z-stage all the way up and down to make sure that the clips behave as expected -- the clip is intended to flex and twist
5. Yell "Look upon my works, ye mighty, and despair!"
6. Apologize to the cat, who is strangely unimpressed