Started out as a remix of someone's work, but so changed now as to irrelevant. Name says it all. I've only printed it in TPU, for which it works great, though I'm sure it would be ok in other materials too.

Attached STLs for a few variants based off of this:

• A Hi-Lift Jack Handle Cap, which has a couple retainer "nubs" added. Designed around the Baja Buster handle actually. That way when it smacks you in the face, it hurts less...
• Jack Shaft Cap is for the handle of my floor jack. Also mostly so when I smack my face on it, it hurts less. Recommend about a 15% infill for this and the above, in TPU of course, for the requisite softness.
• Also included caps for my GreenWorks Pressure washer. The genius of these is, since they are sized around the mating dimensions of the hose and the pressure washer itself, the caps can be connected to keep them clean while the pressure washer is in use.