Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
hariseldon wanted one, and I just so happened to have one printed and still had the .stl.
This is a Starcraft 2 Hydralisk. Original model by Blizzard Entertainment, supports, optimization, and base modeled by me.
©2010 Blizzard Entertainment, Inc. All rights reserved. Wings of Liberty is a trademark, and StarCraft and Blizzard Entertainment are trademarks or registered trademarks of Blizzard Entertainment, Inc. in the U.S. and/or other countries.
Instruções
Print at 20% or so fill, factory settings worked fine for me. After it prints, you need to use wire cutter or an x-acto knife to remove the supports.
BE CAREFUL, the claws and jaws are very delicate on smaller models (and still delicate on large models), cut slowly and controlled so the thin pieces don't snap.
Clean up spaghetti plastic after print and it should look great.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta