This is my simple lamp.

I printed it on an reprap using ABS filament.
Have a look at the instructions for more information.

Attention: Check if the lamp can stand the heat of the bulbs for a few hours. It works perfectly on my lamp but this depends on your lights and material.

Feel free to fork the design.

Bill of Material:

• 1x 19V notebook power supply or - 1x 12V power supply
• 2x lamp holder G4
• 2x light bulb G4 max.10W
• 1x small switch
• 1x set of printed parts
• 4x m4x20 screws

Instructions

• print parts
• smoothen the surface by coating it with a thin layer of acetone
• glue the lamp shade together
• connect the power supply to the switch and light(s)
• assemble the lamp holder
• check if the lamp holder can stand the heat of the bulbs
• mount the lamp holder on the base
• put the lamp shade on the holder
• check if the lamp can stand the heat of the bulbs for a few hours
• ready!