This is a snap together hinge that you can add to your projects. The Customizer allows you to adjust the tolerances and measurements to fit your printer accuracy and project needs. So far I have tested this out on the Kerrby printer at The Bellingham Foundry Makerspace.

I suggest printing without supports. The code needs to be cleaned up a little, but future updates should not affect functionality.

The hinges shown in the photo were made with the following settings: Large hinge on the left: $fn = 70 tabThickness = 2 tabWidth = 6 tabSeperation = 3 tabTolerance = 0.5 pivotTolerance = 2 directDiameter = 5 indentWidth N/A diameterOrWidth = 0 Use ball Diameter ballTolerance = 0.3 backLength = 5 ballRatio = .3

Small hinge on the right: $fn = 70 tabThickness = 1.75 tabWidth = 4 tabSeperation = 2 tabTolerance = 0.5 pivotTolerance = 2 directDiameter N/A indentWidth = 3.2 diameterOrWidth = 1 Use indent width ballTolerance = 0.25 backlength = 3 ballRatio = .3