Camera slider (motorized)

This camera slider is used for DSLR or system cameras but also for action cams. You can use it with or without a motor driver.

Without motor driver, you need:

square tubes 15x15 mm aluminium (for round you have to make your own parts) (buy)
4x tube mounts, bottom (option with M3 inserts) and top with M3 bolts (print) the "loose" one can be tightened with bolts, the "tighten" one can be used without bolts
bearingblock (4x), maybe it can with 3 parts (print)
bearings used are standard type 606 (6176 mm) (buy)
for mounting are used bolt M5x20 and M6x20 for the bearings
aluminium, plastic or wooden plate for mounting the bearing blocks (make)
camera bolt to mount your camera, depending on camera type (1/4") (buy)

For electronic slider you need the following added:

belt mounts to secure the belt, both parts to lock belt (print)
belt: type 2GT-6 about 2m length (buy)
belt pulley mount slider to tighten belt (2 parts print) see also: nutholder on mythings for the wingnuts
2x aluminium pulley wheels (buy)
motor mount for belt pulley, with or without lipo case (print)
motor type Nema 17 Stepper Motor 42 motor 17HS8401 (buy)
electronic box with speed control: - pcb board with some wire (50x70 mm) - arduino nano with mini usb - digital encoder (ky-040) - 7-segment display (TM1637 LED display) - stepper driver board (A3967 EasyDriver Stepper Motor Driver) - on/off switch (optional) - 2 end-switches - power source plug (female jack 5.5 mm)
Arduino program will be included and electronic-schematics
Working: - encoder turning changes speed (incrementing changes according to abs numbers) - encoder push button stops motor and changes direction motor - end switches changes direction. Be aware that the switches are standard low (0 volt) so you can also leave them away.

See also on Instagram @DIYhans If you have any questions, let me know.