A LED lighting solution for the print bed / print head. This uses an adhesive strip of LED's which run at 12Vdc so you can connect them to a cooling fan supply etc.

The LED's are cleverly made so you cut the strip on the line marked in modules of 3 and they only cost $2.95 per 3 LED segment.

I used two strips of 3 LED's and then stuck them with the adhesive backing and a tiny amount of silicone to the underside of the travelling x axis carridge.

Also comes with free printable trolley coin for pupping in the grocery trolley at the supermarket instead of using a $1 or $2 coin. (Because i had to add a file that wasn an image to publish)

Purchase LED strip module from electronics supply store. I got them from Jaycar CAT. NO. ZD0473. http://www.jaycar.com.au/productView.asp?ID=ZD0473&form=CAT2&SUBCATID=976#1

Cut LED strip into 3 LED segment on the line. Solder supply wires onto the LED strip at the correct marked points. Affix LED's in a suitable location.