Designed for 5" props and smaller

Print 2 Bases, 2 Posts, 2 Zeroers, and 1 Base Connector

Requires: 2X 0.7" magnets 0.196" deep 1X at least 3" 8-32 Threaded rod 2X 8-32 nuts

The magnets press-fit quite well into the PLA stands, but may require some sanding for a better fit and glue if needed. To get a point on the ends of the threaded rod, I put one end into a drill and used a belt sander, spinning both the drill and sander to get a nice centered point on the rod. This is required until you have a reasonably sharp point and fits within the stands without creating a lot of friction. All the parts to the stand are interlocking to mount to the other parts requiring a small amount of super glue.