Update 03/22/2016: Made a couple changes. The GPIO now has a cut-away cover. There is also a cover where the MicroSD card slot is located.

Update 03/17/2016: This is the final version. I printed so many to ensure the lid, bottom, posts, and holes lined up. I also dialed in the settings for my printer to make a super smooth top and bottom by printing directly on glass and minimizing visible extrusions.

This is a case for the Raspberry Pi Zero. There are two files; one is the case and the other is the lid. There are four posts which the Raspberry Pi Zero fits onto and the ports line up with the slots on the side and valleys under the GPIO and HDMI solder pads for a flush fit. The lid has four posts with holes to snap down onto the case as well as an opening for the GPIO.