My apologies for the messy 'thing' files. I wasn't expecting to ever upload it and didn't keep good track of my final files for the project ^^;

This add-on for the DeathGun Mask that ferreusveritas made are the eye-diffusers I made which allow the mask to glow red from the center of the eyes. It uses 5mm red leds.

How to construct the eye-diffuser sandwich:

1. Main Diffuser
2. LED holder tube (slide your 5mm led into this)
3. 5mm LED base (feed your LED leads through these holes and bend them out)
4. Deathgun Mask - Lens frame piece (feed your wires through the holes)

The files are as follows:

main_diffuser.stl - The main part you see. It is the diffuser and supports. I left the middle part white and painted the supports and outside border black.

led_holder_tube.stl - This fits into the back of the main diffuser and is the right size for a 5mm led.

5mm led base.stl - This holds the back of the LED and blocks some light from hitting your eyes. You can push the two leads through this, and bend them outward. (I may have scaled this up to around 110% when printing the final. I'm sorry I don't remember exactly)

DeathGun Mask - lens frame piece.stl - This replaces ferreusveritas' original lens holder by adding holes for wires to go through, rather than pinch them in the lens holder 'sandwich'.